IH-526Jod - Overdyed Type III
-
That looks effing cool Ben and you've nailed the fit.
Clean style and clean gums by the looks of it too.
-
Haha, thanks guys! I'm really stoked that this is cut exactly in the different ways that I was hoping according to the measurements. Happy days….been thinking about this one for a while!
-
Ben is the most stylish kid at UCLA
-
Nice fit - did you get it off of B&S or did Giles locate one in your size?
-
Got lucky and found it on sufu
-
New addition, my favorite show of all time
-
New addition,
my favoritegreatest show of all time -
-
Thanks Sean! Got a new addition, need some advice… Should I move the patch up a bit or do you guys think it's good?
-
I would rock it across the bottom of the jacket. Just my .02 though, I think aesthetically it will line up to the bottom better because of the natural alignment if the letters at their base rather than the lack of uniformity at the top. Will just be a better compliment. I think if the letters were on a curved base you would be okay at the top but because they move straight horizontally it's working against the lines of the jacket. Hope that makes sense to you.
-
I would move it up a bit…
New addition,
my favoritegreatest show of all timeand this, since I just saw it…..
-
All comments appreciated, but I think it's sick so it's going on for at least a little. I figure no harm if I get sick of it and take it off….
Tat, I get what you're saying, but the problem with that is that the back panel gets smaller toward the bottom and it's actually too small for the length of the patch.
It will be going on a tad higher though...
-
Ah yes wasn't considering the narrowing. Good call.